Skip to content
MSHA's Safety Targets Program
Hit By Equipment (Surface - Metal/Nonmetal)

Do's and Don'ts


Surface Equipment Operation and Foot Travel at Mines

DO'S
  • Wear reflective materials on clothing when traveling on foot in areas where reduced lighting could affect personal safety.
  • Use radios or other positive or certain means of communication to convey your travel intentions.
  • Make visual contact with equipment operators before walking close to the machines.
  • Be certain that all persons are clear before starting or moving equipment.
  • Provide illumination sufficient for safe working conditions.
  • Ensure a travel lane is clear before moving a vehicle. Train miners to not walk or stand in travel lanes.
  • Look over your shoulder when backing up to eliminate blind spots. When using mirrors, use all available mirrors.
  • Install "rear viewing" cameras on vehicles.
  • Sound horns before moving equipment in areas where miners are present.
  • Leave sufficient distance between mobile equipment to ensure that you are visible to other drivers.
  • Remain in equipment cabs while staging trucks.
  • Train all employees on proper work procedures and hazard recognition and avoidance.
  • Turn the wheels of mobile equipment into a bank or berm, or properly block them when left unattended on a grade.
  • Minimize situations where smaller vehicles need to approach large haul trucks (e.g., arrange for haul truck drivers to have supplies available at the pre-shift meeting place, rather than having supplies delivered to the truck).
  • Equip smaller vehicles with flags or strobe lights, positioned high enough to be seen from the cabs of haulage trucks.
  • Turn on all exterior lights and keep the cab windows free of condensation or other obstructions that affect visibility when driving in inclement weather or reduced visibility.
  • Install signs or signals that warn of pedestrians where persons routinely cross plant roadways on foot.
  • Ensure that all workplaces are kept clean and orderly.
  • Establish rules and use signs or signals warning of hazards at locations where pedestrians and mobile equipment are both performing tasks.
  • Exercise caution when approaching grades and operate mobile equipment in the appropriate gear at speeds consistent with the grade being traveled.
  • Discuss job tasks and identify any potential hazards (conduct a risk analysis) before beginning any work. Identify safe work procedures and take action to eliminate any hazards.
  • Utilize radios to communicate when visual contact cannot be maintained.
  • Monitor personnel routinely to determine that safe work procedures are followed.
  • Always disengage the transmission and set the park brake before leaving the cab.
DON'TS
  • Never cross the path of a moving vehicle.
  • Never turn your back to a vehicle moving in your direction.
  • Don't tune out back-up alarms. Try to recognize the different equipment when more than one alarm sounds.
  • Never assume that the driver has seen you through his/her mirrors.
  • Never leave mobile equipment unattended unless the brakes are set



Some or all of the files available on this page are PDF. For more information on PDF, PDF readers and accessibility issues, please use this link.