In the matter of Petition for Modification
Drummond Company, Inc.
Shoal Creek Mine
I.D. No. 01-02901 Docket No. M-1999-097-C
PROPOSED DECISION AND ORDER
On September 8, 1999 a petition was filed seeking a modification of the application of 30 CFR 75.1909(b)(6) to the front brakes of the Getman diesel grader at Drummond Company, Inc. Shoal Creek Mine, located in Jefferson County, Alabama. The Petitioner alleges that the alternative method outlined in the petition will at all times guarantee no less than the same measure of protection afforded by the standard.
MSHA personnel conducted an investigation of the petition and filed a report of their findings and recommendations with the Administrator for Coal Mine Safety and Health. After a careful review of the entire record, including the petition and MSHA's investigative report and recommendation, this Proposed Decision and Order is issued.
Finding of Fact and Conclusion of Law
Section 75.1909(b)(6) provides that all self-propelled non-permissible diesel-powered equipment must have, in addition to all other requirements, service brakes that act on each wheel of the vehicle such that failure of any single component, except the brake actuation pedal or other similar actuation device, must not result in complete loss of service braking capability.
Petitioner proposes an alternate method in lieu of the front wheel brakes on the Getman/Model RDG-1504 (Serial No. 6297) diesel grader in use at the Shoal Creek Mine. Petitioner proposes to limit the Getman diesel grader speed to ten miles per hour and to train the Getman diesel grader operators to drop the grader blade in the event that the brakes fail.
The alternative method proposed by Drummond Company, Inc. (as amended by the recommendations of MSHA) will at all times guarantee no less than the same measure of protection afforded the miners under 30 CFR 75.1909(b)(6).
On the basis of the petition and the findings of MSHA's investigation, Drummond Company, Inc, is granted a modification of the application of 30 CFR 75.1909(b)(6) for use of the Getman diesel grader at its Shoal Creek Mine.
ORDER
Wherefore, pursuant to the authority delegated by the Secretary of Labor to the Administrator for Coal Mine Safety and Health, and pursuant to Section 101(c) of the Federal Mine Safety and Health Act of 1977, 30 U.S.C., sec. 811(c), it is ordered that Drummond Company, Inc.'s Petition for Modification of the application of 30 CFR 75.1909(b)(6) to the Getman diesel grader in the Shoal Creek Mine is hereby:
GRANTED, conditioned upon the following terms and Conditions:
1. The proposed decision and order is limited in application to Getman/Model RDG-1504(Serial No. 6297). The maximum speed on the Getman diesel grader must be limited to ten miles per hour or less by physically blocking higher gear ratios.
2. Prior to implementing the alternative method:
(a) the Getman diesel grader must be inspected by MSHA and in compliance with the terms and conditions of this Proposed Decision and Order,
(b) grader operators must be trained to recognize appropriate levels of speed for different road conditions and slopes, and
(c) grader operators must be trained to lower the moldboard (grader blade) to provide additional stopping capability in emergencies.
3. Within 60 days after this Proposed Decision and Order becomes final, the Petitioner must submit proposed revisions for its approved 30 CFR Part 48 training plan to the Coal Mine Safety and Health District Manager. These revisions must specify initial and refresher training regarding the terms and conditions stated in the Proposed Decision and Order.
Any party to this action desiring a hearing on this matter must file in accordance with 30 CFR 44.14, within 30 days. The request for hearing must be filed with the Administrator for Coal Mine Safety and Health, 4015 Wilson Boulevard, Arlington, Virginia 22203.
Michael J. Lawless
Deputy Administrator
for Coal Mine Safety and Health